Identificador: 2331
Abierta
PARTE: 12537-1 - EXTRACTORES PARA CASETAS PINTURA - 30” DIAMETRO - 5 HP
AMXmachinery
Descripción
PARTE: 12537-1 - EXTRACTORES PARA CASETAS PINTURA - 30” DIAMETRO - 5 HP
USADO
MOTOR 5 HP, 220/440V, 3 FASES
30” DIAMETRO
MARCA DAYTON USA
Pago y Devoluciones
- Forma de pago
- Visa/Mastercard/American Express, Transferencia/Deposito Bancario
Publicar mensaje
Ingresar to ask the seller a question.
AMXmachinery
CABEZALES PARA MOLDURADORA - NAVAJAS ESPIRAL
CABEZALES PARA MOLDURADORA - NAVAJAS ESPIRAL2, 4 Y 6 NAVAJAS----------------------------------------------------------------------------------------------------------20° Angulo de Corte / 18° Angulo Espiral / Espiral mano DerechaLargo de Corte, Diametro Total, # Navajas, Parte #60mm 125mm 2 MSH125-2-60100mm 125mm 2 MSH125-2-100130mm 125mm 2 MSH125-2-130150mm 125mm 2 MSH125-2-150180mm 125mm 2 MSH125-2-180230mm 125mm 2 MSH125-2-230240mm 125mm 2 MSH125-2-240310mm 125mm 2 MSH125-2-31060mm 125mm 4...
AMXmachinery
SIERRA ESCUADRADORA 3200 MM
PARTE # 2TA-TS-P3200MA - SIERRA ESCUADRADORA - 3200 MM NUEVA CON GARANTIAHeavy duty construction provides vibration free operation. Easy to set up and adjust.Manual raise, lower and tilt of main blade and scoring saw.Scoring unit provides clean, accurate, chip free cutting, ready for edge banding.Sealed main shaft bearings (lubricated for life) with vibration dampening system.Highly accurate, freely moving sliding table with wear resistant guide rails and rollers.Specially designed roller carri...
AMXmachinery
PARTE: 12269 – MONTACARGAS – 5,000 A 6,000 LBS - CATERPILLAR
PARTE: 12269 – MONTACARGAS – 5,000
A 6,000 LBS - CATERPILLAR
USADO
- BUENAS CONDICIONES
RODADA 10 ATRÁS
RODADA 12 ENFRENTE PARA TERRACERIA
MOVIMIENTO LATERAL DE CARGA
TORRE LEVANTE 3 SECCIONES
GAS LP
AMXmachinery
SIERRA DOBLE 45 GRADOS – 2 SIERRAS 14” - PISTORIUS EMN-14
PARTE: AMX-10028 - SIERRA DOBLE 45 GRADOS – 2 SIERRAS 14” - PISTORIUS EMN-14Used - Excellent conditions – Used for samples only2 Motors 2 HP,
208/230/460 Volts, 60 Hz, 3450 RPMSaw harbor
5/8"Dust exits 2 of
4" diameter, requres aprox. 850 CFMAir use 72 CFM at
65 PSI based in 15 cycles/minTable height
36-1/8" (917 mm) Pneumatic pedalEach cut takes 4 to
6 seconds
Weight 405 lbs (184 kg)